This is our FAB3130 module for the Edcor PC Series output transformers. These output transformers are inexpensive, but I find they have a flavorful sound. The PC Series though has a limited headroom and saturates early… maybe that’s the reason for the flavored sound?  I find that these Edcor transformers add thickness and body to the sound. You’ll definitely notice it. Inexpensive, but effective!

Just like our FAB3110 Module, there is a Logic Level control input so you can select either 1:1, or 1:2 ratio with the output transformer.

UPDATE: Made a Rev.B FAB3130 board, increasing the size of the PCB to match the dimensions of our FAB3110 Output Transformer Module (for Cinemag, Crimson Audio). Tonight, I sent the boards out  to the PCB manufacturer… we should get our finished prototype boards sometime next week.

Continue Reading…

Here are some photos showing the FAB1215 Power Supply Module powering some FAB modules via a ribbon cable.

Continue Reading…

Here’s one of the simplest way to use our FABModules….  Hook up the following FABs together:

FAB2010 – XLR Input Module
FAB2110 – Input Transformer Module
FAB3010 – XLR Output Module

All that’s missing is Power, if you want to enable the -20dB Pad, Phantom Power and Polarity Reverse functions. Otherwise, it will still work without power applied. After all, it’s just an input transformer inserted in your signal chain.

Continue Reading…

Populated our FAB3010 XLR Output Module.  There is a Logic controlled relay, used for Polarity Reverse function.  All you need to do is apply a Logic “1” to the header pin (which can be +3.3V, +5V, or your V+ voltage) and it will trigger Polarity Reverse.

Continue Reading…

Received our FAB3010 XLR Output Module.  Just to recap, the FAB3010 Module includes a relay-controlled Polarity Reverse. All you need to do is apply Logic “1” to the header pins (located on upper left corner) and it will switch the relays on/off.  A Logic “1” can be anywhere from +3.3V to +5V, or up to your V+ voltage.

I need to make a Revision B board because I want to move the XLR jack farther out, so it won’t have any problems with clearances if you want to mount the XLR jack on a .125″ thick case panel.  But other than that, I think it looks good.

Will try to populate this board in the next day or so, so I can test the Polarity Reverse logic control. I don’t foresee any problems, but the proof is in the pudding as they say.

Continue Reading…